The last thing that anyone who owns a home wants to go through is a house fire, but the fact is that these happen much more often that some people may think and it is generally due to carelessness around the house with heat and electricity. There are a number of appliances in your home that are hazardous and require special attention, but many people tend to disregard some of the warnings and care suggestions that come with these items and they neglect to read the instruction manuals.
One of the most dangerous, yet convenient items that you can have in your home is a space heater. They are wonderful if you cannot afford to have gas heat or the extra expense on the electric bill to heat the house during the winter, but when used incorrectly or in an inappropriate area of the home, they can cause fires extremely quickly. You should always use caution when using space heaters in your home and if possible, do not use them in homes with small children due to the risk of burns.
Space heaters should not be used on carpeted surfaces or on rugs unless the heated part is located at least 6 inches off the floor. This is common with heaters that also have a fan function. The further away the heat is from the floor, the safer the heater will be on a carpeted surface, should you have to use it there.
Space heaters should also not be used at night unless the cold is just unbearable. Use these only when there are people around to watch them closely and turn them off when you leave the house. Many fires occur both at night and when people are out of the house, so turning these off and unplugging them while you are gone is a good idea.
Fires are also caused by electric blankets more often than people might realize. Too many have woken up in the middle of the night with their beds on fire because they left the blanket on while they were asleep and leaving them on like this is a bad idea for that exact reason. You should also never walk on an electric blanket, since the heating cords inside them can be damaged fairly easily. Try to store these in areas where they have no chance of getting wet, as well, such as the top of the closet.
Showing posts with label laptop. Show all posts
Showing posts with label laptop. Show all posts
Friday, January 18, 2008
Exhaust Fans and Ditra Prevent Mold
Mold can grow all over the house but there are a few rooms that are a bit more at risk for mold growth than all the others and this is usually due to the amount of inherent moisture that passes through them on a day to day basis. You may not realize it if you are just moving into a home of your own after college or getting out of your parents’ house, but the kitchen and the bathroom are the two areas of the home that require the most attention to keep them in tip top shape over the years (or just months) you will be living there.
All surfaces in your bathroom that are porous are in danger of mold growth, which is why you never want to install a porous flooring material in this room. Materials like hardwood or carpet are very bad for this and other wet rooms of the house like the kitchen and laundry room, so installing something like ceramic tile or sealed stone is going to be much better. Even if you install these hard materials, you can still have problems with mold and water damage underneath them if they are not sealed properly. You should check regularly for missing areas of caulking or grout, since this can allow water to get to the wooden subfloor and cause it to rot. You also need to check for this in the kitchen, since the same problem can come up. You can help prevent it, though, by installing Schluter-Ditra before you put the flooring material in. This is a layer of waterproofing material that will give you an added level of protection against water damage and mold growth.
Another problem appears on the ceiling if there is no vent or fan to allow the steam and heat from the room to escape to the exterior of the house. The ceiling will absorb this moisture since it has nowhere to escape to and will become waterlogged. Mold starts to grow on wet surfaces like this in a relatively short period of time, so making sure that the steam created by the bath or shower gets out is very important. This is also a problem in the kitchen when there is no exhaust system over the stove. You can fix this in both of these areas and other areas of the home with high humidity by installing an exhaust fan that will pull it out of the room with the flick of a switch.
All surfaces in your bathroom that are porous are in danger of mold growth, which is why you never want to install a porous flooring material in this room. Materials like hardwood or carpet are very bad for this and other wet rooms of the house like the kitchen and laundry room, so installing something like ceramic tile or sealed stone is going to be much better. Even if you install these hard materials, you can still have problems with mold and water damage underneath them if they are not sealed properly. You should check regularly for missing areas of caulking or grout, since this can allow water to get to the wooden subfloor and cause it to rot. You also need to check for this in the kitchen, since the same problem can come up. You can help prevent it, though, by installing Schluter-Ditra before you put the flooring material in. This is a layer of waterproofing material that will give you an added level of protection against water damage and mold growth.
Another problem appears on the ceiling if there is no vent or fan to allow the steam and heat from the room to escape to the exterior of the house. The ceiling will absorb this moisture since it has nowhere to escape to and will become waterlogged. Mold starts to grow on wet surfaces like this in a relatively short period of time, so making sure that the steam created by the bath or shower gets out is very important. This is also a problem in the kitchen when there is no exhaust system over the stove. You can fix this in both of these areas and other areas of the home with high humidity by installing an exhaust fan that will pull it out of the room with the flick of a switch.
Cell Phone Water Trouble
We all know that water and electronics do not mix, but the fact is that many people end up letting these sensitive items come into contact with water no matter how careful they are. Most people have dropped something into the sink or the bath tub that did not belong there, but dropping a cell phone into one of these is a nightmare, especially for those of us who have our social lives strapped to them. If you kill our phone, you do away with all those contacts, since most of us do not have rolodexes anymore.
Having one of the new cell phones that are on the market today brings a lot of perks to the table, such as being able to save pictures, music, numerous ring tones, the ability to watch videos, surf the internet, check e-mail, and a number of other things, but all this can be completely done away with if the phone becomes soaked with water. Fortunately, there are a few things that you can do to save your phone should this happen.
If the phone is connected to its A/C adapter and plugged into the wall, unplug it before reaching into the water to fish it out. Do not reach into the water while the phone is still plugged in, but try to get it out of the water before 30 seconds, but 20, if possible. After retrieving it from the water, remove the battery, SIM card (if your phone has one), and set them aside. Dry off the exterior of the phone and its components with whatever is handy.
Put the phone in a bowl of uncooked rice and leave it there overnight to dry. The rice will pull the moisture out of the phone. If you can stand to, leave it there a day or two until you are sure that no moisture remains in it. Trying to turn the phone on prematurely will do exactly what you are trying to prevent.
You should also be aware that there is a water damage indication sticker on the inside of the phone located around the battery pack and deeper into the phone on the circuit board. These are in most cell phones these days to stop consumers from making false warranty claims and stating that their phone is defective, when actually, it was water damaged. Water damage is not covered under most cell phone warranties.
Having one of the new cell phones that are on the market today brings a lot of perks to the table, such as being able to save pictures, music, numerous ring tones, the ability to watch videos, surf the internet, check e-mail, and a number of other things, but all this can be completely done away with if the phone becomes soaked with water. Fortunately, there are a few things that you can do to save your phone should this happen.
If the phone is connected to its A/C adapter and plugged into the wall, unplug it before reaching into the water to fish it out. Do not reach into the water while the phone is still plugged in, but try to get it out of the water before 30 seconds, but 20, if possible. After retrieving it from the water, remove the battery, SIM card (if your phone has one), and set them aside. Dry off the exterior of the phone and its components with whatever is handy.
Put the phone in a bowl of uncooked rice and leave it there overnight to dry. The rice will pull the moisture out of the phone. If you can stand to, leave it there a day or two until you are sure that no moisture remains in it. Trying to turn the phone on prematurely will do exactly what you are trying to prevent.
You should also be aware that there is a water damage indication sticker on the inside of the phone located around the battery pack and deeper into the phone on the circuit board. These are in most cell phones these days to stop consumers from making false warranty claims and stating that their phone is defective, when actually, it was water damaged. Water damage is not covered under most cell phone warranties.
Subscribe to:
Posts (Atom)
